Traditional Carbon Arrow Shaft

Tough and affordable traditional carbon shaft . Under the bonnet this is the same carbon type and design as in our awesome fluo-series which we tested to the extreme over two years and are more than satisfied with these sticks.

Uncut 400, 500 and 600 spine shafts are 32″ length, 700 spine is 30″ and all can be cut to your required length by entering it in the field at the bottom of this list. length and can be cut to length for you. Glue-in inserts and push-in TRAD nocks in a colour of your choice are included with each shaft.

Cutting:

We can cut these shafts to length for you for $2 per arrow.

Which shaft for which bow + Weight and Out Diameter details

For bows 20# to 30#: 700 Spine – ID 6.2, 5.3 GPI, OD 7.06

For bows 35# to 40#: 600 Spine – ID 6.2, 5.7 GPI, OD 7.11

For bows 45# to 50#: 500 Spine – ID 6.2, 6.7 GPI, OD 7.27

For bows 55# to 60#+ : 400 Spine – ID 6.2, 7.5 GPI, OD 7.42

Straightness: +/-  .003″

Safety Tested

We have tested this shaft rigorously to make sure the carbon fibres are cross woven. This means the inner part of the carbon tube is spun using an endless carbon thread that runs around and upwards and the outer carbon fibres are in a 90degree angle to the inner ones. This makes the arrow a lot tougher as it can resist impact better but it also makes it safer: The most dangerous thing in archery is when an arrow breaks at release. This arrow will usually break clean and straight, which can still cause an injury – but the design provides a good level of protection from thin and sharp carbon splinters lodging under the skin. This is a big and dangerous issue found in most other cheap carbon arrows that have all carbon fibres running in a straight line forward only.

But remember:  always flex before you shoot to identify any issues!